このエントリーをはてなブックマークに追加
ID 30259
フルテキストURL
著者
Nakata, Takayoshi Okayama University
Takahashi, N. Okayama University
Fujiwara, K. Okayama University
Kawashima, T. Okayama University
抄録

The optimal design of an injection mold for producing a stronger multipole magnet is carried out using the finite element method and the direct search method. It is shown that the maximum flux density in the cavity obtained by the optimal design is about 2.6 times higher than that of the initial shape determined empirically. 3-D analysis of the nonlinear magnetic field in the injection mold with complicated structure is also carried out. The calculated flux distribution on the cavity surface is in good agreement with the measured one

キーワード
electromagnets
finite element analysis
magnetic flux
備考
Digital Object Identifier: 10.1109/20.278717
Published with permission from the copyright holder. This is the institute's copy, as published in Magnetics, IEEE Transactions on, Nov 1991, Vol. 27, Issue 6, Part 2, Pages 4992-4994.
Publisher URL:http://dx.doi.org/10.1109/20.278717
Copyright © 1991 IEEE. All rights reserved.
発行日
1991-11-01
出版物タイトル
Magnetics
27巻
6号
開始ページ
4992
終了ページ
4994
資料タイプ
学術雑誌論文
言語
English
査読
有り
DOI
Submission Path
electricity_and_magnetism/76