JaLCDOI 10.18926/19584
フルテキストURL Mem_Fac_Eng_OU_29_1_1.pdf
著者 Uno, Yoshiyuki| Kubota, Shin-ichiro| Yokomizo, Seiichi| Ogata, Kojiro| Tada, Nobuhiko|
抄録 Scribing of copper coated alumina ceramic board with Q-switched YAG laser used for the maskless direct patterning of circuit board is experimentally investigated, which leads to efficient production of trial circuit board. Better dividing of alumina circuit board 655μm in thickness can be attained by the scribing of about 100μm depth. Higher repetition frequency of laser irradiation leads to smaller notch angle and lower breaking load.
出版物タイトル Memoirs of the Faculty of Engineering, Okayama University
発行日 1994-11-30
29巻
1号
開始ページ 1
終了ページ 6
ISSN 0475-0071
言語 English
論文のバージョン publisher
NAID 120002309083
JaLCDOI 10.18926/15385
フルテキストURL Mem_Fac_Eng_OU_27_1_1.pdf
著者 Uno, Yoshiyuki| Kubota, Shin-ichiro| Nakajima, Toshikatsu| Ogata, Kojiro| Tada, Nobuhiko|
抄録 Direct patterning of copper coated ceramic circuit board is experimentally investigated with Q-switched Nd:YAG laser in order to shorten the time of the trial manufacture of electronic circuit board and to adapt the flexible design change. It is pointed out that the fast direct patterning the speed of which reaches about 100 mm/s is possible if the repetition frequency and the average power are selected properly. Furthermore cutting off and/or drilling of ceramic board are also possible under the condition that the repetition frequency is less than 3kHz. This technique makes it possible the mask1ess patterning of ceramic circuit board which has been widely used recently in place of conventional glass-epoxy or phenolic resin circuit board, and it leads to the shorter time limit of delivery as compared with the conventional end-milling method.
出版物タイトル Memoirs of the Faculty of Engineering, Okayama University
発行日 1992-11-25
27巻
1号
開始ページ 1
終了ページ 10
ISSN 0475-0071
言語 English
論文のバージョン publisher
NAID 120002307702